This section explains how to back up and restore the system of manager server of Cloud Services Management.

To back up the databases and configuration for manager server, perform the following procedure:

1. Stop the System

   Stop manager server. For details on how to stop Cloud Services Management, refer to "2.1.1.2 Stopping".

2. Back up the Databases

   Back up the content in each data dictionary for the three databases used by manager server.

   %FSCSM_HOME%\db\CSMSYSTEM
   %FSCSM_HOME%\db\CSMMETERINGLOG
   %FSCSM_HOME%\db\CSMACCOUNTING

   Use any method to back them up. An example is shown below.

   Example

   Using Explorer, back up the content in each data dictionary to a compressed folder in the ZIP format.

3. Back up Logs

   %FSCSM_HOME%\log

   Back up the logs if necessary.

4. Back up the Configuration Files

   Configuration files are stored in the following two folders. Back up the contents of these folders.

   %FSCSM_HOME%\conf

   %FSCSM_HOME%\sys\conf

   Use any method to back them up.

5. Back up required software

   Back up required software for this product. For details on procedure, refer to manual of required software.

   Note

   When user information is registered or modified on this product, backup of ServerView Operations Manager must be performed.

   If previous backup of ServerView Operation Manager is available and the differences from this product don't exist, the backup of ServerView Operations Manager is unnecessary.

6. Start the System

   To resume operation after backup, start Cloud Services Management.

   For details on how to start Cloud Services Management, refer to "2.1.1.1 Starting".

To restore the databases and configuration for Cloud Services Management, perform the following procedure:

1. Stop the System

   Stop Cloud Services Management. For details on how to stop Cloud Services Management, refer to "2.1.1.2 Stopping".

2. Restore Databases

   According to the backup method that was used, back up all of the old files that exist in the data dictionary and then place the data that was already backed up into the data dictionary.

   If the operation example described in "4.2.1.1 Backup" in this manual has been performed, perform the following operation:

   • Using Explorer, copy the files that were backed up to a compressed folder in the ZIP format into each data dictionary.

3. Restore Log and Configuration Files

   Depending on procedure for backup, put backup data under log or configuration file folder after all old files under log and configuration folder are saved.

4. Restore Required Software

   Restore required software for this product. For details on procedure, refer to manual of required software.

5. Start the System

   To resume operation after restoration, start manager server.

   For details on how to start manager server, refer to "2.1.1.1 Starting".